NE555 Square Wave Signal Generator Module

Square Wave Generator

NE555 Signal GeneratorIt is a module that generates square waves. Signal outputs are programmable by software, so they can be adjusted easily. You can easily use this module with development boards such as Arduino and Raspberry Pi.

SD Datalogger Technical Specifications

• As a square wave signal generator, it generates a square wave signal used for experimental development.
• It is used to generate a square wave trigger signal and to start a stepping motor.
• Adjustable pulses can be generated for the MCU and act as a crystal.
• It can generate pulses that can be adjusted depending on the control circuit
• Size: 31mm x 22mm
• Master Integrated: NE555
• Input Voltage: 5V-15V DC
• When the power supply is 5V, the output current can be about 15mA; When 12V power supply, output current can be around 35mA
• Giriş akımı:>= 100mA
• Output amplitude: 4.2V V-PP to 11.4V V-PP. (Different input voltage, output amplitude will be different)
• Maksimum çıkış akımı:> = 15MA (5V güç kaynağı, V-PP% 50'den büyük),>= 35MA (12V power supply, V-PP greater than 50%)
• LED indication output (low level, LED on, high level, LED off, low frequency, LED flashing)
• Output frequency range can be selected:
  • LF file: 1Hz ~ 50Hz
  • IF file: 50Hz ~ 1kHz
• High frequency file: 1KHz ~ 10kHz
• HF file: 10kHz ~ 200kHz
• Output duty cycle can fine-tune, duty cycle and frequency cannot be adjusted separately; Adjusting the duty cycle will change the frequency.

Useful Links

• Arduino Module TypesYou can examine.